Mitsubishi Electronics WS-55511 Projection Television User Manual


 
12
13
Back Panel
Inputs 1-4
These inputs can be used for the connection of a VCR, Super VHS (S-VHS) VCR, DVD player, standard
satellite receiver or other A/V device to the TV. Please note that if you connect to the S-VIDEO terminal,
the VIDEO terminal is deactivated. The VIDEO terminal is active when there is no S-Video connection.
Output (Monitor and PIP)
The Monitor Output sends the TV audio and video signals from Ant-A, Ant-B and Inputs 1-5 to an A/V
Receiver or other analog A/V equipment. Monitor Output will also provide the signals, converted to analog
signals, received from Ant-DTV and IEEE-1394 products. There will be no video signals from digital
products if the original signals are copy protected.
From VGA, Component 1 and 2 and Input-DTV, no signals will be sent. The PIP output sends the PIP’s or
POP’s audio signal to an amplier or wireless headphones. If no PIP or POP is displayed, the PIP output
will not send any audio.
Antenna (ANT-A, LOOP OUT, and ANT-B)
ANT-A and ANT-B receive analog NTSC signals from VHF/UHF antennas or an analog NTSC cable
system. LOOP OUT sends the ANT-A signal out to another component, such as a cable box or VCR.
4
IR Emitter-Repeater
Connecting IR emitters here allows the TV to pass IR commands from most IR remote controls to other A/V
devices that are out of range of the remote control.
5
VGA
This input can be used for the connection of a computer. Please see Appendix B for signal compatibility.
6
Component Inputs 1-2
These inputs can be used for the connection of A/V equipment with component video outputs, such as a
DVD player. Please see Appendix B for signal compatibility.
7
DTV Input
This input is used to connect an external DTV receiver, and can be congured for HDTV signal types
component (YPrPb), RGB sync on green, and RGB plus H&V. Please see Appendix B for signal
compatibility.