Mitsubishi Electronics WS-55511 Projection Television User Manual


 
In This Section . . .
Edit NetCommand™, cont’d.
Figure 1. AVR to VCR Connection screen.
AVR to VCR Connection Screen
Figure 1
This screen is displayed only when a VCR is the
device being added or changed. The AVR to
VCR Connection screen allows you to conrm the
connection of the A/V Receiver’s record output
to the VCR’s line input. This connection allows
recording of signals from the TV Monitor output,
through the A/V Receiver, to analog VCR.
If you have more than one VCR, only one VCR can
be used for setup of recordings by NetCommand.
This is also true when using both a legacy VCR
and the analog side of a DVCR. When connecting
cables from the AV Receiver to the VCR, take care
when selecting the VCR which will then be used
for all recordings by NetCommand. Ensure that
this screen is correctly checked for the only device
connected to the AV Receiver.
Figure 3. IR Code screen - (VCR2 example).
Figure 2. Input-DTV Connection screen.
Input-DTV Connection Screen
Figure 2
This screen displays only if the device selected in
the Connection screen is connected to Input-DTV.
The Input-DTV Connection screen allows you to
select which connection type, RGB or Component
Y/Pb/Pr you are using to connect your cable box,
DBS, or HDTV Receiver when connected to Input-
DTV.
IR Code for [Device] Screen
Figure 3
This screen only displays if a device added has the
same IR code as a device previously added. You
can specify the IR setting for the new device. For
example, for the second Mitsubishi VCR you can
specify the IR Code setting to VCR-B, if the primary
Mitsubishi VCR is using the VCR-A IR code.