Filter
Top Products
26
27
Figure 1. Programming the TV remote to control your
NetCommand™ A/V devices.
To Program the Remote to Control
the TV and NetCommand™ A/V
Products:
(See NetCommand™ Supported Devices, for the list
of A/V products supported by the NetCommand™
System.)
1. Move the slide switch at the top of the
remote to the TV layer.
2. Press and hold the POWER button on the
remote control.
3. Enter the three digit code of 935, and then
release the POWER button on the remote
control.
4. The remote control is now programmed to
send NetCommand™ signals to the TV. The
TV can also control the IEEE 1394 devices
and selected NetCommand™ supported IR
devices. See the NetCommand™ guide for
details.
Programming the Remote Control to Control NetCommand
™
NetCommand™ CODE to ENTER
TV Control and NetCommand™ 935
Devices: