Filter
Top Products
MODELS: VS-45609 / VS-50609 / VS-55609 / VS-60609 / VS-60719 / VS-70709
Page 11
CABINET SEPARATION PROCEDURE (VS-70709)
1c. VS-70709 Cabinet Separation Precedure
1. Remove the Screen Assembly and disconnect
all cable harnesses between the Frame
Assembly and the PCB-SIGNAL (refer to
1a.
Front Cabinet Disassembly
).
2. Remove 4 screws “a” securing the top and
bottom cabinet sections (Figure 1-3).
3. Lift the cabinet top straight up until the guide
pins are clear.
4. Carefully place the cabinet top on the floor.
5. Place the cabinet bottom in the desired
location.
6. Reverse the procedure and mount the cabinet
top on the cabinet bottom.
7. Reinstall the the Screen Assembly and
connect all cable harnesses between the
Screen Assembly and the PCB-SIGNAL.
Model VS-70709 cabinets are assembled in two pieces. These two pieces may be separated to allow easier delivery
and setup.
Note:
The Guide Pins under the cabinet top may break if mishandled. Keep the cabinet top straight when remov-
ing and installing. DO NOT tilt the cabinet top while resting on the guide pins.
Figure 1-3