Filter
Top Products
62
63
Remote Control Functions: Channel Selection and Sleep Timer
Channel Selection
For Ant-A or Ant-B Channels: You have three
options...
• Enter three numbers (for channel 2, press 002).
• Press the channel number and ENTer (for
channel 2, press 2, then ENTer).
• Enter the channel number and wait four
seconds. The TV will change automatically.
Sleep Timer
Setting the Sleep Timer:
1. Press SLEEP on the remote control.
Note: A message indicating the length of time
the sleep timer is to be set for is displayed on the
TV screen.
2. Each press of SLEEP increases the time
displayed by 30 minutes, until the maximum value
of 120 minutes is reached.
3. After 5 seconds of inactivity, the message will
disappear.
4. Press SLEEP to view the remaining time
before the timer turns the TV off.
Canceling the Sleep Timer:
1. Press SLEEP to display the on-screen
message.
2. Press SLEEP repeatedly until OFF is
displayed.
For Ant-DTV Channels
(When Ant-DTV is the current device):
1. Enter two or three numbers for the major
channel number. If three numbers are pressed,
the separator is automatically added and
you may proceed to step 2. If two numbers
are pressed, you must add the separator by
pressing the SUB button on the remote control.
2. Enter a 1-digit sub-channel number and
wait four seconds. Enter a 1-digit sub-channel
number and press ENTer. Or enter 2 digits for
this sub-channel and the TV will automatically
switch channels.
Remote Control Functions:
Operation of PIP and POP
Picture-In-Picture (PIP) and Picture-Outside-
Picture (POP) features allow you to view
programming in different ways. While watching
the main screen, you can display programs from
other channels and other inputs. You can display
a single PIP, side-by-side pictures, three POPs, or
nine POPs.
• POP: side-by-side pictures
• 3 POP
• 9 POP
• PIP
• PIP/POP: off
To turn PIP/POP off, wait at least 10 seconds, and
press
PIP/POP.
Activating the PIP and POP
Figures 1-5 on following page
Press PIP/POP to activate the PIP/POP option.
With each press of the PIP/POP button on the TV
remote control (within 3 seconds of each other), the
PIP/POP will cycle through the following display
options.