Mitsubishi Electronics XD700U Projection Television User Manual


  Open as PDF
of 61
 
EN-25
Signal menu
Signal
Adjust
MENU
Exit
Select
V. Position
Fine sync
Computer Input
Overscan
Hold
User
On
Auto
90%
0
0
Tracking
0
H. Position
0
User
Adjust
MENU
Exit
Select
Clamp Width
Shutter(U)
Shutter(L)
Shutter(LS)
Shutter(RS)
Off
1
LPF
0
0
0
0
Clamp Position
1
OK
ITEM SETTING FUNCTION
H. Position 0-999 Select this setting to adjust the horizontal position of projected images.
V. Position 0-999 Select this setting to adjust the vertical position of projected images.
Fine sync 0-31 Select this setting to eliminate flickering or blurs, if they appear, when you are
viewing projected images.
Tracking 0-2800
Select this setting to eliminate vertical wide stripes, if they appear, when you are
viewing projected images.
Computer Input Auto Automatically sets the appropriate setting.
RGB Select this setting when you connect the projector to high definition video
equipment having R, G, and B output terminals.
YCbCr/YPbPr
Select this setting when you connect the projector to a DVD player or other device
having Y, C
B
, and C
R
(or Y, P
B
, and P
R
) component video output terminals.
Overscan 100%-90% Use this setting to adjust the display area of projected images.
Hold Off / On Use this setting to adjust projected images when flagging occurs in the upper
area of the screen.
User OK The Signal-User menu is displayed for the following adjustments.
Clamp Position 1-255 Use this setting to correct solid white or solid black that appears in projected
images.
Clamp Width 1-63 Use this setting to correct solid black that appears in projected images.
LPF On / Off Select this setting to enable or disable LPF.
Shutter(U) 0-20 Use this setting to adjust projected images when noise appears in the top
part of the image.
Shutter(L) 0-20 Use to adjust the image when noise appears on the bottom part of the image.
Shutter(LS) 0-20 Use this setting to adjust projected images when noise appears in the left half
of the image.
Shutter(RS) 0-20 Use this setting to adjust projected images when noise appears in the right
half of the image.
• Horizontalstripsmayappearintheenlargedprojectedimage,thoughtheseconditionsarenotamalfunction.
• Whenyouchangethevalueofthehorizontalorverticalpositiondrastically,noisemayappear.
• Theadjustablerangeoftheverticalpositionvariesdependingonthetypeoftheinputsignal.Theimagemaybestationary
even when the value is changed. These conditions are not a malfunction.
• Shutterdoesnotworkcorrectlyduringkeystoneadjustment.
• WhenyouincreasethevalueofOverscan,noisemayappearonthescreen.
Important:
• YoucansetthePicture,Signal,andSignal-Usermenusonlywhenthesignalisinputted.
Menu operation (continued)
 previous next