Mitsumi electronic 838 Series CRT Television User Manual


  Open as PDF
of 108
 
8 1. Basic Setup and Operation
For assistance call 1(800) 332-2119
Before You Begin
Review the important safety, installation, and oper-
1.
ating information at the beginning of this book.
Choose a location for your TV.
2.
• Allowatleastfourinchesofspaceonallsides
of the TV to help prevent overheating. Over-
heating may cause premature failure of the TV
as well as shortened lamp life.
• Avoidlocationswherelightmayreflectoffthe
screen.
• Seethestandrequirementson page 2.
Install the batteries in the remote control.
3.
Plug the TV into an AC power outlet.
4.
TV Tips
Turning the TV On or Off
Point the bulb end of the remote control at the •
front of the TV and press the
POWER
key.
Press the •
POWER
button on the TV control
panel.
If You Turn Off the TV by Mistake
Press •
POWER
again, within about 60 seconds,
to have the TV come back on immediately.
If the •
STATUS
indicator is flashing green, (about
60 seconds after you shut off power), wait a
few moments for the indicator to stop flashing
and press
POWER
to turn the TV on again.
Controlling Sound Volume
Press •
VOL
to adjust the sound level.
See also• “Controlling A/V Receiver Sound
Volume” on page 31.
Changing Channels (antenna sources)
NOTE: Perform a channel scan to enable recep-
tion of digital channels. See Setup > Channel,
page 55.
Enter the channel number using the number •
keys on the remote control and press
ENTER
.
For a two-part digital channel, such as 3-1,
press
3
—
CANCEL
1
to include a dash (separator).
Press •
CH
to change channels one channel at a
time.
Press and hold •
CH
to move quickly through
channels.
Press •
LAST
to return to the previously tuned
channel.
Press •
GUIDE
to display ChannelView channel
listings, highlight a channel, and press
ENTER
.
Use the Fav (Favorites) feature to tune to up to •
nine favorite channels. See page 28.
Use the •
CH
key to tune to preselected groups
of channels using ChannelView custom
channel banks. See page 29.
First-Time Power-On
Press the
1.
TV
key to
ensure that the remote
control is in
TV
mode.
TV
TV
Aim the bulb end of the
2.
remote control at the TV and
press the
POWER
key
.
Wait
for the Welcome screen.
If you wish to change the
3.
menu language to Español,
press .
Press
4.
to highlight EXIT.
Press
ENTER
to clear the
menu.
Downloaded From TV-Manual.com Manuals
 previous next