Filter
Top Products
9
TROUBLESHOOTING
ERROR CODES ARE FLASHING LED LIGHTS AT 1 SECOND INTERVALS
Stow Flashing: This is not an error but motors moving.
Find Flashing: Invalid Mode Dome and Skewable.
Find and Stow Flashing: Invalid Mode.
Peak Flashing: Motor Time Out. No counts Elevation.
Peak and Stow Flashing: Motor Time Out. No counts Azimuth.
Peak and Find Flashing: Motor Time Out. No counts Skew.
Peak, Find and Stow Flashing: Limit Error Elevation.
DVB Flashing: Limit Error Azimuth.
DVB and Stow Flashing: Limit Error Skew.
DVB and Peak Flashing: Only Main sat found.
DVB, Peak and Stow Flashing: Main sat not found but Secondary sat found.
DVB, Peak, Find and Stow Flashing: Signal lost NO LNB Power
Lock Flashing: No satellite found.
Lock and Stow Flashing: Over Temperature on Satellite Receiver.
Lock and Find Flashing: Dish did not raise high enough.
Lock, Find and Stow Flashing: Coax cables on backward.
Lock, Peak, Find and Stow Flashing: Could not find main sat after Skew.
Lock and DVB flashing: EEPROM failure.
Lock, DVB and Stow flashing: AGC Control Failure.
NOTE: Before calling Technical Support please
perform a “Test Dish” and press “Find” one more
time before calling.
Technical Support
- MotoSAT Customer/Technical Service – (1-800-247-7486) - Available Mon-
Fri 9:00 a.m. to 5:00 p.m. Mountain Standard Time.
● Please have your MotoSAT Model # and Satellite Receiver Brand
prior to calling Customer/Technical Support.