MotoSAT Nomad 2 Satellite TV System User Manual


 
7
NOMAD 2 UNIVERSAL CONTROLLER “REAR” PANEL
Power Supply Interface: Is used to connect the 12 VDC 4 AMP power supply to
provide power to the NOMAD 2 Universal Controller. (Note: Only use the power supply
provided by MotoSAT or a power source known to have at least a 4 Amp min.)
Control Cable Interface: Connects the mount by way of a 9 pin conductor cable to the
NOMAD 2 Universal Controller. The cable is color coordinated for exact connection
configuration. (See Figure Below)
Wiring to 9 Pin Control Connector
Black-Brown-Red-Orange-Yellow-Green-Blue-White-Purple
(Purple is only used on Skewable Mounts, and not required on Non-Skewable Mounts)
Power Connector
Control Cable
Maintenance Port
To Satellite Receiver
Satellite In
From Dish
P1 P2 P3
+12V -GND Unused