MotoSAT Nomad 2 Satellite TV System User Manual


 
5
To initiate a REPEAK – Skewable Mounts ONLY - Pressing the Find
button, when “on satellite” and the signal strength shows weakness, will
re-peak the dish for a higher signal quality when using the twin LNB
skewable dish model(s) MD500 or triple LNB MDHDTV ONLY. (Note
:
Single LNB non-skewable dishes “re-peak” during satellite transition.)
STOW
: (Stowing the Dish)
Pressing this button returns the dish to its stowed or travel position.
LED’S:
LNB: When lit, this LED indicates the coax cable from the receiver has been
correctly connected to the NOMAD 2 Universal Controller, and the receiver has
power. (Note: The LNB LED is illuminated once the coax cable of the receiver
has been connected, but does NOT indicate the Controller has power).
LOCK: When lit, this LED indicates the “strongest” or “highest” signal strength
of the satellite has been achieved and is locked onto the desired satellite.
DVB: When lit, indicates the DVB is actively locking onto the satellite
PEAK: When lit, this LED indicates the dish has found a signal and is adjusting
for the “strongest” or “highest” signal strength of the satellite.
FIND: When the “Find” button has been pressed, the Find LED will blink until a
satellite has been identified and can establish a connection. Once the satellite has
been identified, the Find LED will remain solid. (The Stow LED also blinks
indicating motor movement.) If the Nomad 2 is locked onto a satellite with a
skewable dish, pressing the “Find” button again will activate a re-peak routine
which will verify the dish alignment to the satellite for optimum signal level for
the skewable dishes (MD500 for Dish Network and MHDTV for DirecTV).
Pressing the Find button on non-skewable dishes (Dome and Executive) allows
you to switch between satellites.
STOW: When the “Stow” button has been pressed, the Stow LED will blink
indicating motor movement as the dish is being stowed. Once the dish has been
stowed, the Stow LED will remain solid for a short period of time and then the
power will automatically turn off.