Filter
Top Products
6
OPERATION PROCEDURES
TO FIND A SATELLITE
If the Mount Type is SKEWABLE (Models MD500 and MHDTV)
1. Turn ON power.
2. After 10-15 seconds (after Nomad power up sequencing) press the
FIND button.
The dish will search out and lock onto the proper programmed
satellite.
3. Pressing the FIND button while on satellite will initiate a re-peaking
sequence.
If the Mount Type is NON-SKEWABLE (Executive (One LNB))
1. Turn ON power.
2. After 10-15 seconds (after Nomad power up sequencing) press the
FIND button.
The dish will search out and lock onto the proper programmed
satellite.
3. Pressing the FIND button while on satellite will initiate a ‘FIND
NEXT SATELLITE’ routine.
If the Mount Type is a NON-SKEWABLE FREEDOM (using the Nomad 2)
1. Turn ON Power.
2. If ON a Satellite when turning the Power ON, the system will search
for the next available satellite in sequence.
3. If NOT ON a Satellite, the system will search for the primary satellite
for the service subscribed to.
4. Once the system has located a satellite, the Power will turn OFF.
When Power is turned ON the system will go through steps 1-4 above.
TO STOW THE DISH
1. Press the STOW button and the dish will stow, or return, to the proper
travel position.
After the dish has been properly stowed, the
power will automatically turn OFF.