Filter
Top Products
English-8
English-9
English
3. Remote control:
Remove the cover of the
battery compartment. Insert the
2 batteries supplied (Type AAA
1.5V).
4. Power cord installation
• The equipment should be
installed close to an easily
accessible power outlet.
• Fully insert the prongs into
the power outlet socket.
A loose connection may
cause image degradation.
If there is power to the display
the front LED at the bottom of
the display will be either blue
or red. A blue LED means the
display is powered on. A red
LED means the display is in
standby mode.
5. Power:
Press the power key on the
remote control or press the
power button located on the
side of the display. The display
will power on.
Please make sure to connect the
power plug to the wall outlet socket
after connecting the display to the
power cord!
1. Install the base stand;
place the display on a solid
surface.
Ensure that the display is
placed in a position to allow
free ow of air. Do not cover
the ventilation openings on the
back cover. Do not place the
display near any open ames
such as a lighted candle or
other exposed ame sources.
Avoid heat, direct sunlight and
exposure to rain or water. Do
not expose the equipment to
any liquid.
2. Connect the antenna cable or
CATV cable to the aerial socket
ANT IN 75Ω at the back of the
display.
Min
1 m
Power
Video
Comp PC/HDMI TV
E321
E421
Power Key