Filter
Top Products
- 4 -
The additional disk enclosure weighs 34 kg or more. Hold the disk enclosure
firmly with at least three people to carry it. Carrying the additional disk
enclosure only by two or less people may strain their back.
Select the place where the additional disk enclosure can be connected to the
AC outlet by using the attached power cord or the power cord approved by
NEC.
Insert the plug of a power cord into an AC outlet securely. If some clearance
remains between the plug of the power cord and the AC outlet, dust may
enter into the clearance. This then may cause fire to occur.
Provide sufficient margins for the cables connected to the additional disk
enclosure so that legs may not be trapped by the cables. Avoid power plugs
and FC connectors from suffering excess forces.
Do not use cables connected to the additional disk enclosure with them
leaving bent. If so, a fault or fire may occur.
Use the cables approved by NEC as those connected to the additional disk
enclosure and check the destinations to which the cables are connected. In
addition, always lock power cords and FC cables when they are connected.
Use the power source independent from TV or radio. Otherwise, a noise may
be generated.
To connect a cable to the mating connector, make sure that the connector of
the cable is not damaged and any pins are not bent. Using a cable not
approved by NEC or a damaged cable may cause fire to occur.
To disconnect a cable from the mating connector, always hold the connector
of the cable. Do not hold the cable itself to disconnect it.