Filter
Top Products
- 31 -
(4) Writing information on option label
To allow the options installed in the disk enclosure to be found by external view, the
label indicating the options available for the installation is put on the additional disk
enclosure.
If a disk drive is added, write down the last two digits of model number and a check mark
at the corresponding field on the label to indicate the addition as shown in the figure
below.
Note: The figure above indicates that a single NF2300-SM413E is installed at
location '00' in NF2300-SE41E.
If NF2300-SM412E is added, enter the last two digits of model number ("12")
in "NF2300-SM4 (E)" field. Write down a check mark at the location in
which the disk drive is installed, which appears in the area to the right of the
model number field.
Similarly, if NF2300-SM413E or NF2300-SM422E is added, enter the last two
digits of model number ("13" or "22") in "NF2300-SM4 (E)" field. Write
down a check mark at the location in which the disk drive is installed, which
appears in the area to the right of the model number field.
If disk drives are installed at locations '00' and '01,' write down check marks
at the '00' and '01' fields.
Write down a check mark as shown in the figure.
Enter the last two digits of model number
("13" in the example).