Filter
Top Products
- 9 -
(2) SERVICE LED (orange)
The SERVICE LED goes on orange if an error occurs in the additional disk
enclosure.
The LED is off while the disk enclosure operates normally.
(3) Disk drive/dummy tray
Disk drive: Contains a hard disk drive (HDD) with the dedicated tray.
Dummy tray: Contains only the dedicated tray with no hard disk drive.
* The additional disk enclosure NF2300-SE41E is not equipped with disk drives
at the shipment. To use the additional disk enclosure, add disk drives sold
separately.
* The disk drives installed in the disk enclosure are dedicated to the FC loop at
2Gbps.
A mixture of 1Gbps and 2Gbps disk drives is not permitted.
Do not install any 1Gbps disk drives in the disk enclosure.
The following measures are adopted to prevent insertion of a 1Gbps disk drive:
A) A 1Gbps disk drive cannot go into the position where a 2Gbps disk drive
is locked.
B) The ejector color is different.
(4) HDD READY LED (green)
The HDD READY LED is lit green while the disk drive operates normally. The
LED blinks when the disk drive transfers data.
The HDD READY LED blinks during the self-test or initialization just after
power-on.
(5) HDD FAULT LED (orange)
The HDD FAULT LED goes on at the occurrence of an error in the disk drive. The
LED is off while the disk drive operates normally.
(6) Ejector
The ejector is used to install or remove the disk drive or dummy tray. In the normal
operation status, the ejectors fix disk drives or dummy tray to the additional disk
enclosure.
When inserting the disk drive into the disk enclosure, push it as far as it
will go and then lock the ejector.
Incorrect insertion may cause malfunction.