NETGEAR ANT24D18v2 TV Antenna User Manual


 
Statement of Conditions
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
Safety
Radiation Pattern: Elevation (Vertical plane)
17
16
Radiation Pattern: Azimuth (Horizontal plane)
In the interest of improving internal design, operational function, and/or reliability, NETGEAR reserves the right to
make changes to the products described in this document without notice. NETGEAR does not assume any liability
that may occur due to the use or application of the product(s) or circuit layout(s) described herein.
Federal Communications Commission (FCC) Compliance Notice:
Radio Frequency Notice
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.
In the U.S., the ANT24D18v2 antenna should only be used with devices that have been FCC approved for use with it.
Please check the NETGEAR web site at http://www.NETGEAR.com/go/antannas_fcc for an updated list of FCC
approved devices.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures: (1) Reorient or relocate the
receiving antenna, (2) Increase the separation between the equipment and receiver, (3) Connect the equipment into an
outlet on a circuit different from that to which the receiver is connected, (4) Consult the dealer or an experienced
radio/TV technician for help.
Federal Communications Commission (FCC) and European Radiation
Exposure Statements
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. In order to
avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not
be less than 50 cm (20 inches) during normal operation. This device should not be co-located with other transmitters.
European Emission Statement
For EU, use of any antenna requires careful planning and extra consideration to comply with EU emissions, health
standards and regulations. It is recommended that a qualified professional installer service is consulted for site survey
and proper installation. Antenna installation must comply with the maximum level authorized by each country. See
http://www.NETGEAR.com/go/antannas_eu for product combinations that comply with EU regulations.
The NETGEAR wireless devices WG302, FWG114P, FVM318, ME103, and FM114P have been tested with the
antenna ANT24D18v2 and have successfully passed all relevant tests contained in the Standard for the Safety of
Information Technology Equipment for Europe (EN 60950-2000) equivalent to North American Standards UL 60950,
Third Edition, CAN/CSA-C22.2 No. 60950-00, Third Edition and Australian/New Zealand Standards ACA TS 001-
1997, and AS/NZS 3260:1993 with A1 through A4.
0
330
315
300
285
270
255
240
225
210
195
180
165
150
135
120
105
90
75
60
45
30
15345
-20 -10 0 10
dB
0
345
330
315
300
285
270
255
240
225
210
195
180
165
150
135
120
105
90
75
60
45
30
15
-20
-10
0 10
dB