Nokia 121 T Satellite TV System User Manual


 
GB 20
Navi Bars
Maintenance folder
System Information
When you enter the Maintenance folder you find general informa-
tion about which hardware and software version your Mediamaster
is running on.
Reinstall
Use this option only if you have to start the complete installation
procedure from scratch. If you continue from here, all your previ-
ous settings, access code and favourite channels etc. will be erased!
If you do not want to perform a reinstallation you can leave
this menu when the warning is displayed by pressing “back”.
SW update
Your Mediamaster will advise you from time to time of any new
software upgrades using information sent by TV broadcasters
through your aerial.
This will appear as a message on your tv screen asking you to press
ok to start the download. You are strongly advised to accept the
download as this might enable you to receive the new features and
or services that may be available to you . You can choose to post-
pone the download for a more convenient time by pressing the back
button. The message will appear again provided that the software
is still broadcast.
Note : These messages will only appear if your Mediamaster
has been switched on from Standby.
It is advisable to put you Mediamaster into standby when not in use.
After downloading of a new software version, all your previous set-
tings, access code and favourite channels etc. will be erased!
IMPORTANT! The updating may take a while.
NEVER turn off the Mediamaster, never use the remote control or
disconnect the antenna cable during the download procedure! This
will damage the software and the receiver will have to be sent in
for service!