Filter
Top Products
GB 20
Channel search in progress
This menu will be shown while the Mediamaster is searching for
TV and radio channels.
All channels that are found will be listed on the screen.
Please note that the search procedure may take a few minutes.
You can cancel the search at any time by pressing select.
When the search procedure has ended, a message will tell you
how many TV and radio channels have been found.
• Press select to continue.
Time adjustment
The time is adjusted by using cursor up/cursor down, ±1/2 an
hour at a time. You can also adjust the minutes by using cursor
left/cursor right.
• Press select to finish the first time installation and to open the
NaviBars.
First-time installation
Advanced manual search
The information that must be entered in this menu is available in
satellite TV magazines or on the Internet.
You can use this menu if you are looking for some “special” chan-
nels (i.e. non-DVB standard channels) which can only be found
when you have entered the necessary settings here.
Transponder frequency: Specify the frequency in MHz.
Polarisation: Select Horizontal, Vertical, Circular left or right.
Symbol rate: Enter symbol rate with the numeric buttons.
PID Video: Enter the PID (Packet Identifier) for the video signal.
PID Audio: Enter the PID for the audio signal.
PID PCR: Enter the PID for the PCR (Programme Clock Refer-
ence).
Adjust motor: This alternative will only be available if you have
set the motor antenna configuration. If necessary, adjust the mo-
tor for the current satellite.
• Press select to tune in channels using the given parameters.
All channels that are located using the advanced manual search
will automatically be given a generated name, for example,
P0001 for the first channel, P0002 for the second, etc.
• Press select to save the new channel or back if you not want
to save it.