Filter
Top Products
25
TV Installation and Connection Guide
Connecting to a Satellite Receiver or Cable Box with A/V Connectors
1.Using Audio and S Video cables, connect the satellite receiver's Audio
and S Video OUT jacks to the TV Audio and S Video IN jacks.
2.Connect a 75-ohm coaxial cable from your cable or antenna to the TV
Ant (Antenna) jack.
Note: When you connect video equipment to both the same Video and
S Video input jacks, display will automatically select S Video first.
To view S Video signal, please disconnect Video jack or turn off the
Video signal on the video equipment.
S-Video is strongly recommended for use if your VCR or video equipment
has it because S-Video input has better quality of picture than a composite
Video signal.
Note: You can also use the Video 2 jacks located on the TV rear, or
Video 3 located on the right side of the display to connect additional
video equipment.
Disconnect all power sources before making any connections.
A/V cable with RCA connector
S VIDEO cable
Yellow
Red
White
ANT
DTV
Audio
Output
C
C
b
b
b
b
P
P
C
C
r
r
r
r
P
P
VIDEO-1VIDEO-2
Component-1Component-2
Rear of TV
75-ohm coaxial cable
Satellite Receiver or Cable Box