Filter
Top Products
65
Adjusting On Screen Displays (OSD)
OSD-DTV
Adding Channels Manually
You can add channels manually if they aren't detected by the Auto Scan
utility using the following steps:
On the Channel menu page, select "Manual Scan", and then use the
or button to select the channel connection: Air, Cable STD,
Cable IRC, or Cable HRC.
Press Enter to highlight the input column, then press numeric buttons
to input the channel number. The channel frequency is automatically
shown on right side of the input column.
Press the Enter button
when the messages "Add
channel" and "press Enter
to add channel" are shown.
If the ATSC signal is found
and locked, you will see
the Status message "Get
No.XX 8VSB channel
success". Press EXIT or
Menu to leave the menu
and watch the program,
or to scan other channels.
If the signal is not locked,
you will see a "no channel"
message. You can scan the
signal again or refer to the
signal level bar "Signal"
for aligning the direction of the antenna to improve the signal.
When the signal is locked and the receiver is on the channel, you can
check the signal level.
Note: Contact the antenna installer if you have trouble locking the signal.
Press the EXIT button to return to the main menu or press the MENU
button to exit the menu system.