Filter
Top Products
16
EN
CONNECTIONS
Connection to an Audio System
• When you change the connections, all devices should be turned off.
• Refer to the manual accompanying external devices for more information.
2-Channel Analog Audio Connection
AUDIO IN
LR
analog audio input jacks
RCA audio cable
audio
this unit
AUDIO OUTPUT (DOWN MIX L/R)
stereo system
Digital Audio Connection
DIGITAL AUDIO INPUT
COAXIAL
DIGITAL AUDIO INPUT
OPTICAL
audio
this unit
AUDIO OUTPUT (DIGITAL OPTICAL/COAXIAL)
AV receiver / amplifier
digital audio
optical cable
digital audio
coaxial cable
or
digital audio
optical input jack
digital audio
coaxial input jack
Supplied cables used in this connection are as follows:
• RCA audio cable (L/R) x 1
Please purchase the rest of the necessary cables at your local store.
Note for Digital Audio Optical Cable
• Digital audio optical cable may be damaged when bent at sharp angles. Endure cables are coiled in loops with a
diameter of 6 inches (15cm) or more when storing them.
• Use a cable which is 9.8 feet (3m) or shorter.
• Insert cable plugs firmly into the connectors when making connections.
• If a plug has dust or is dirty, clean it with a soft cloth before inserting it into a connector.
Note
• When connecting to a 2-channel audio stereo device, use the AUDIO OUTPUT (DOWN MIX L/R) jacks. If the AUDIO
OUTPUT (ANALOG 7.1ch) jacks are used, set “7.1ch Audio Out” in the “Audio” menu to “2 Channel” (Refer to page
38). For software recorded in multi-channel, analog signals that have been down-mixed into 2 channels are output.
(For sources which are prohibited from down-mixing, only the FRONT L/R signals are output.)