Filter
Top Products
Connections
Introduction
11
Point the remote controller at the
remote sensor and press the
buttons.
Distance: About 5 m(16-11/16 feet) from
the front of the remote sensor
Angle: About 30° in each direction of
the front of the remote sensor
* Do not expose the remote sensor of the
DVD player to a strong light source such
as direct sunlight or illumination. If you do
so, you may not be able to operate the
DVD player with the remote controller.
Preparing the Remote Controller
Insert the batteries into the remote controller so you can use it
to operate the DVD player.
Improper use of batteries may cause battery leakage and corrosion. To
operate the remote controller correctly, follow the instructions below.
• Do not insert the batteries into the remote controller in the wrong
direction.
• Do not charge, heat, open, or short-circuit the batteries. Do not
throw the batteries into a fire.
• Do not leave dead or exhausted batteries in the remote controller.
• Do not use different types of batteries together, or mix old and new
batteries.
• If you do not use the remote controller for a long period of time,
remove the batteries to avoid possible damage from battery
corrosion.
• If the remote controller does not function correctly or if the operating
range becomes reduced, replace all batteries with new ones.
• If battery leakage occurs, wipe the battery liquid from the battery
compartment, then insert new batteries.
• The batteries should last about one year with normal use.
Operating with the Remote Controller
This section shows you how to use the remote controller.
2
3
1
30°30°
Within about 5 m (16-11/16 feet)
Notes on batteries:
• Direct the remote controller at the remote sensor of the DVD player.
• Do not drop or give the remote controller a shock.
• Do not leave the remote controller near an extremely hot or humid
place.
• Do not spill water or put anything wet on the remote controller.
• Do not open the remote controller.
Notes on the remote controller:
Open the cover.
Insert batteries (AA size).
Make sure to match the + and – on the
batteries to the marks inside the battery
compartment.
Close the cover.