Filter
Top Products
60
Programming the Commands of Other Remote
Control Units into the Remote Controller
Erasing the programmed command
from one button
You can only erase memorized commands and not preset ones.
Press and hold down the desired
MODE button for the command,
press the SEARCH button, and
then release both buttons.
When you release the buttons, the SEND/LEARN
indicator lights.
Press and release the button for
the command you wish to erase.
When you press the button, the SEND/LEARN
indicator turns off. When you release the button, the
lamp lights again.
Press and release the same button
again.
The SEND/LEARN lamp flashes twice. The
memorized command is erased.
Note
If no button is pressed for more than 30 seconds during the programming, the
SEND/LEARN indicator flashes three times quickly, and the remote
controller exits the programming mode. Resume from Step 1.
1
2
3
Erasing all the commands
programmed under a MODE button
Press and hold down the desired
MODE button, press the SEARCH
button twice, and then release both
buttons.
When you release the buttons, the SEND/LEARN
indicator flashes twice slowly and then lights again.
Press and release the same MODE
button again.
When you release the button, the SEND/LEARN
indicator flashes twice slowly. This erases all the
commands memorized to the MODE button.
Notes
• If no button is pressed for more than 30 seconds, the SEND/LEARN
indicator flashes three times quickly and the remote controller exits the
programming mode. Resume Step 1.
• If you perform an invalid operation during programming, the SEND/
LEARN indicator flashes three times quickly and the remote controller
exits the programming mode. Resume from Step 1.
• If many commands have been programmed to the MODE button, then the
SEND/LEARN indicator may remain lit for some time during Step 2. This
is not a malfunction.
1
2
RECVR
SEARCH
DVD
SEND/LEARN
indicator
DV-S939(US_E)p56-60.p65 10/2/00, 3:26 PM60