Filter
Top Products
POWER
MUTE
PIP
SOURCE (select the small picture's signal source)
SWAP (switch between large picture and small picture)
PIP-SIZE (size of small picture)
PIP-POS (small picture's position)
SCALING (scale of screen)
MODE (Audio system group)
FREEZE (frozen picture)
CCD
MAIN MODE (main picture's signal source)
MENU (menu adjustment)
SLEEP
VOL +/- (Volume +/-)
CH (Channel)
09
RETURN
CH. (displaying channel)
TV, S-VIDEO, AV, YPbPr1, YPbPr2, SCART/D4, VGA, DVI (signal sources)
To turn on LCD display or enter into standby mode.
Press the button to shut down the voice of LCD display. Press again or press volume +/- to restore the
original volume.
Press the button to activate Picture In Picture mode (Please refer to P10 for details)
Press the button to select the small picture's signal source (Please refer to P10 for details)
Switch between large picture and small picture under PIP mode.
Change the size of small picture under PIP mode.
Select the small picture's position under PIP mode.
Activate the screen-scaling mode. 4:3 Mode / Panoramic / Fill all / Wide
Press MODE button and button to select STEREO, MONO, or SAP. (for American NTSC)
Press MODE button and button to select STEREO, MONO, DUAL 1 and DUAL 2. If there's no second
Press FREEZE to freeze picture.
Press CCD to activate subtitle. This function is applicable to the American NTSC system.
Sequentially switch to the signal sources as follows: TV/CVBS(AV)/S-VIDEO/SCART (for Europe only)
/YPbPr1/YPbPr2 or D4 (for Japan only)/VGA/DVI.
Press MENU to activate the LCD display menu. Press again to quit the menu. You can press
to change direction and confirm your selection.
Press this button repeatedly to set the sleeping time at 0/30/60/90/120 minutes. LCD display cuts its
power as soon as the automatic sleeping time is up. To cancel your selection, simply press the button
continually until 0 appears.
Adjust LCD display volume.
Select channel.
Press 0~9 to select channels from 01 to 125. If the channel number you select is larger than 125,
picture will be halted in the previous channel without any switch.
Return to previous channel.
Press CH to display the current channel.
Press the signal source you want. This button allows you to switch between signal sources.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
18.
19.
20.
LCD display installation method Remote controller
08
language available for the signal received LCD display will not audio out, please back to mono mode. (for Europe)