Filter
Top Products
First Time Configuration/Basic Operations
Initial setup
Make sure that you have inserted the batteries in the remote control, have connected your antenna to the TV
properly, and have connected the AC power.
Press the Power Switch on the TV, then press POWER to
turn on the TV.
1
2
The first time you use the TV, you need to configure your TV.
To configure your TV:
15
Installation Guide
OSD Language
English
Channel Tuning
Exit
Exit
Channel Tuning
2 %...
ATV
ATV
DTV
Radio
Press <Menu> to skip.
Press <Exit> to exit.
: 2
Programme(s)
: 0
: 0
Programme(s)
Programme(s)
78.50MHz
OK
Start
Now the Installation Guide screen appears with Channel
Tuning highlighted. Press OK to begin the auto tuning for all
available channels,
. It may take several minutes, please wait until it is
finished.
During searching, the screen will display a report about found
stations.
When complete, it will go to digital programme position one.
Now channel list has been created and you can start to watch
TV.
Note: During ATV tuning, if you want to skip it and go to DTV
tuning, press MENU. To exit tuning, press EXIT.
first for ATV then DTV (including Radio)
channels
3
Turning the TV on or off
To turn the TV on or off:
Plug the power cord into an AC power outlet. Press Power
Switch on the TV.
Now the set is in standby mode. Wait some seconds until
the power indicator lights up, then press POWER to turn
on the TV. (Be sure to wait some seconds before pressing
POWER button. If you promptly press POWER button then
the TV may not respond or act wrongly.)
Press button again to turn off the TV and put the TV in
standby mode.
To cut off the power completely, press Power Switch on the
TV.
Warning: When the TV is in standby mode, power is still flowing
into the TV. To save power, please press Power Switch to
completely cut off the power. After you turn off the TV, you should
wait at least 5 seconds (the power indicator goes out)before you
turn it on again.
Note: If the TV does not receive a broadcast signal for several
minutes, the TV goes into standby mode automatically.
1
2
3
Power Switch