Filter
Top Products
Preparations
Installing and removing the stand
To install the stand:
Cautions:
Make sure that you handle your TV very carefully when attempting assembly or removal of the stand. If you are not
sure of your ability to do this, or of your ability to use the tools necessary to complete this job, refer to a professional
installer or service personnel. The manufacturer is not responsible for any damages or injuries that occur due to
mishandling or improper assembly.
The speaker is not intended to support the weight of your TV. Do not move or handle your TV by the speaker. This
can cause damage to your TV that is not covered by the manufacturer's warranty.
Before attempting assembly or removal of the stand, unplug the AC power cord.
You must install your TV into the stand in order for it to stand upright on a cabinet or other flat surface. If you intend to
mount your TV on a wall or other vertical surface, you must remove the stand column.
1. Carefully place your TV screen face-down on a cushioned, clean
surface to protect the screen from damages and scratches.
2. Secure the stand to the TV with the three provided screws.
If the stand is provided, please read these instructions thoroughly before attempting this installation.
NOTE:
The appearance of this product in these illustrations may differ from your actual TV, and is for comparative
purposes only.
To adjust the viewing angle:
o o
! Tilt the screen forward 5 or backward 10 .
Caution: When adjusting the viewing angle, be careful not to tip over
your TV.
To attach your TV to a wall-mount bracket (not provided)
1. Carefully place your TV screen face-down on a cushioned, clean
surface to protect the screen from damages and scratches.
2. Remove the three screws that secure the TV to the stand base, then
remove the stand base.
3. Remove the screws holding the stand column to the TV, then remove
the stand column.
4. Secure the wall-mount bracket to the back of your TV using the four
screws provided with the bracket.
To install a wall-mount bracket (not provided)
9
o
10
-5
o
Note: To avoid interference between the jacks, wall-mount
bracket, and wall, the wall-mount bracket must be more than
40 mm thick, and the RF or VGA cable must have a 90-degree
plug.