Filter
Top Products
Utilities
46
Position
Adjust
MENU
Exit
Install
Picture
Sound
On
12 : 00 A.M.
On
12 : 00 A.M.
On
12 : 00 A.M.
DTV 0
NSW/ACT
Auto clock
Set Current time
On time
On time setup
Off time
Off time setup
On time PR
On time volume
Time zone
Time
Utilities
20
Move to Off Time in the Time menu
Select the Off Time to "On using the " VOL " button.
5. Press the "SLEEP" button
By pressing the "SLEEP" button on the remote controller repeatedly,
you can select one of the following settings:
Sleet Timer: Off => 30 => 60 => 90 => 120 => Off
Then set will turn off after the time you select.
Move to On time setup with the " PR " buttons.
To go to On time setup, press the " VOL " buttons.
Place the cursor to Clock with " VOL " buttons.
Set the Clock with the " PR " buttons and then press
the Menu button to complete.
Place the cursor to Minute with " VOL " buttons.
Set the Minute with the " PR " buttons and then
press the Menu button to complete.
Place the cursor to AM/PM with " VOL " buttons.
Set the AM/PM with the " PR " buttons and then
press the Menu button to complete.
Note:
Information of Auto clock is required to DTV (DVB-T) signal.
If an active signal is not present for about 30 minutes, the set will automatically turn to ST-BY mode.
Position
Adjust
MENU
Exit
Install
Picture
Sound
On
12 : 00 A.M.
On
12 : 00 A.M.
On
12 : 00 A.M.
DTV 0
NSW/ACT
Auto clock
Set Current time
On time
On time setup
Off time
Off time setup
On time PR
On time volume
Time zone
Time
Utilities
20
Position
Adjust
MENU
Exit
Install
Picture
Sound
On
12 : 00 A.M.
On
12 : 00 A.M.
On
12 : 00 A.M.
DTV 0
NSW/ACT
Auto clock
Set Current time
On time
On time setup
Off time
Off time setup
On time PR
On time volume
Time zone
Time
Utilities
20
4. Setting the Off time / Off time Setup
MENU
VOL-
VOL+
PR+
PR-
MENU
VOL-
VOL+
PR+
PR-