Filter
Top Products
11
Parts and their functions
+CLP: Detail edge overshoot clip
This is used to limit the length of the overshoot parts of the
detail edge components.
–CLP: Detail edge undershoot clip
This is used to limit the length of the undershoot parts of
the detail edge components.
KNEE: Detail edge knee
This function applies the knee to the detail edge parts.
CRM: Chroma detail
This function boosts the detail in the high chroma
saturation.
CRSP: Chroma detail crisp
This is used to remove the very faint noise components
below the level set from the chroma detail components.
CRED: Chroma detail reduce
This is used to suppress the chroma detail edge.
SKIN_DTL: Skin tone detail
This is used to set the skin tone detail function to ON or
OFF.
SKIN_LVL: Skin tone detail level
This is used to set the chroma saturation of the parts
where the skin tone detail is applied.
ZEB: Skin tone area zebra
This is used to set whether or not to apply zebra to the
areas where coring is applied as the skin tones to the Y
signals in the PM output.
PHAS: Skin tone area phase
This is used to move the areas recognized as the skin
tones in the range of 153 to 93 along the Q axis on the
color vector display.
WIDTH: Skin tone area width
This is used to widen the areas recognized as the skin
tones in the range of 1 to 20 along the I axis on the color
vector display.
CRSP: Skin tone detail crisp
This is used to remove the very faint noise components
below the level set from the skin tone detail components.
>Matrix control switch [MATRIX CONTROL]
This is pressed to change the correction amounts for the
R-G, R-B, G-R, G-B, B-R and B-G chroma saturation.
R-GR-BG-RG-B
–100 +1+10
B-RB-G
00
MTX 12GAINPHASE
Cy_B00
MTX 12, GAIN, PHASE
These are used to select the following 12-axis matrix
adjustment items: G, G_Cy, Cy, Cy_B, B, B_Mg, Mg, Mg_R,
R, R_Ye, Ye and Ye_G.
GAIN
This is used to adjust the chroma saturation (gain) of the
items set using MTX 12 in the range of –127 to +127.
PHASE
This is used to adjust the phase of the items set using
MTX 12 in the range of –127 to +127.
?SYSTEM
HEAD, CCU OPT LEVEL:Camera, CCU light reception
strength level
These indicate the light reception strength margins of the
camera head and CCU.
RET1, RET2, RET3, RET4: Return video settings
These are used to set the input allocations of the return
signals.
DCMD: Down-conversion system selection
This is used to select the down-conversion system.
UCMD: Up-conversion system selection
This is used to select the up-conversion system.
HEAD OPT LEVEL πππππ
CCU OPT LEVEL πππππ
RET1RET2RET3RET4
HDSDI1HDSDI2HDSDI3HDSDI4
DCMDUCMDDCLKUCLK
SPSPONON
HBARSBARPATHOSET
ARIBSMPTOFF7.5%
SDI4MSELMLINK
PMMIXON
ANLGO_SELSYNCTYPE
SDRGBONTRI
H_COHFIN(HDTV)
99123
H_COHFIN(SDTV)
99123
SCCOSCFIN(SDTV)
730
SH_HSH_V
090H
VER