Filter
Top Products
12
Parts and their functions
SCCO (SDTV): Subcarrier phase coarse adjustment
This is used to coarsely adjust the phase of the subcarrier
signal in relation to the SDTV genlock sync signal.
SCFIN (SDTV): Subcarrier phase fine adjustment
This is used to finely adjust the phase of the subcarrier
signal in relation to the SDTV genlock sync signal.
SH_H: SD/HD horizontal phase
This is used to adjust the horizontal phase of the SDTV
output and HDTV output.
SH_V: SD/HD vertical phase
This is used to set the vertical phase of the SDTV output
and HDTV output to line 0 and line 90 (advanced by 90H
for HDTV).
VER: ROP software version
This indicates the software version of this unit.
@FUNC control switch
DCLK: Down-conversion link
This is used to decide whether to go with the down-
conversion system control based on the AUX external
input or set the down-conversion independently.
UCLK: Up-conversion link
This is used to decide whether to go with the up-
conversion system control that is linked to the down-
conversion system or set the up-conversion
independently.
PATHO: Pathological pattern output
This is used to forcibly output the pathological pattern.
SET: Color bar setup setting
This is used to set the color bar setup.
SD14: HD SD14 output selection
This is used to set the HD SD14 output of the CCU as the
PM or normal output.
MSEL: Monitor switch selection setting
This is used to set the monitor switch selection to PM,
WFM or the PM-WFM link mode.
MLINK: Shading link setting
This is used to set whether to link the monitor when the R,
B or G shading switch has been selected.
ANLG: CCU analog output setting
This is used to set the analog output of the CCU to the HD
or SD component.
O_SEL: Output select
This is used to set the analog output of the CCU to RGB
or YPbPr.
SYNC: Sync waveform addition setting
This is used to select whether to add the sync waveform to
the analog output.
TYPE: Analog sync phase coarse adjustment
This is used to set the sync waveform to be added to the
HD analog output to binary or tri-level.
H_CO (HDTV): Horizontal sync signal phase coarse
adjustment
This is used to coarsely adjust the phase in relation to the
HDTV genlock sync signal.
H_FIN (HDTV): Horizontal sync signal phase fine
adjustment
This is used to finely adjust the phase in relation to the
HDTV genlock sync signal.
H_CO (SDTV): Horizontal sync signal phase coarse
adjustment
This is used to coarsely adjust the phase in relation to the
SDTV genlock sync signal.
H_FIN (SDTV): Horizontal sync signal phase fine
adjustment
This is used to finely adjust the phase in relation to the
SDTV genlock sync signal.
ALC: Auto iris level
This is used to adjust the auto iris level of the lens.
SPED: Auto iris speed
This is used to set the feedback speed of the auto iris.
WNDW: Auto iris window
This is used to set the image detection area window of the
auto iris.
PEAK: Peak/average setting
This is used to set the ratio between the average and peak
values of the auto iris image detection.
ALCSPEDWNDWPEAK
0014
POWERSPEED(FAN)
ONLOW
2D-M2D-ECOMB
OFFOFFLOW
AUTO SETUP MODE
OUTSIDE FULL
MPEDFSEL
3%FCTRY
BRIGHTCONT
230
DTLCAMNO
ON1
BUZZBLACK(PAINT)
SDFLR
<CARD>MODEEXE