Panasonic BDP-440 Blu-ray Player User Manual


 
21
En
02
Connecting the USB memory
device
Caution
Be sure to turn the player’s power off before
connecting or disconnecting USB memory devices.
Use empty USB memory devices (on which nothing is
stored).
If the USB memory device is write-protected, be sure
to disable the write-protection.
Placing excessive loads on the plug may result in
poor contact, making it impossible to write data on
the USB memory device.
When a USB memory device is connected and the
player’s power is turned on, do not unplug the power
cord.
USB external hard disks cannot be connected to the
player.
Note
Devices may not work if connected to the USB port via
a memory card reader or USB hub.
Connecting to the
network through LAN
interface
By connecting this player to the network via the LAN
terminal, you can play audio files stored on the
components on the network, including your computer,
using HOME MEDIA GALLERY inputs.
Connect the LAN terminal on this receiver to the LAN
terminal on your router (with or without the built-in DHCP
server function) with a straight LAN cable (CAT 5 or
higher).
Turn on the DHCP server function of your router. In case
your router does not have the built-in DHCP server
function, it is necessary to set up the network manually.
For details, see Setting the IP address on page 44 .
LAN terminal specifications
LAN terminal: Ethernet jack (10BASE-T/100BASE-TX)
Note
Refer to the operation manual of the equipment you
have as the connected equipment and connection
method may differ depending on your Internet
environment.
When using a broadband Internet connection, a
contract with an Internet service provider is required.
For more details, contact your nearest Internet
service provider.
USB memory device
Player’s front panel
USB memory device
BDP-LX55’s rear panel
WAN
321
LAN
LAN cable
(commercially available)
Router
Internet
Modem
LAN cable
(commercially
available)
PC
BDP-LX55’s rear panel
BDP-140_VXCN5_IBD_EN.book Page 21 Wednesday, September 28, 2011 9:52 AM