Filter
Top Products
Advanced operations
RQT6977
22
Changing settings
For analog connection (➜ page 7)
Change speaker presence and size a, delay time b, and channel
balance c to suit the speakers you have connected when you select
“Multi-channel” (3 or more speakers are connected).
1. Press [3, 4, 2, 1] to select the item and press [ENTER].
2. Press [3, 4] to select the setting and press [ENTER].
Icon examples:
Surround speaker (LS)
≥Large:When the speaker supports low-frequency (under 100 Hz)
reproduction.
≥Small:Select when the speaker does not support low-frequency
reproduction.
If the subwoofer is set to “No”, the front speakers will automatically be set
to “Large”.
(Effective when playing multi-channel discs)
For optimum listening with 5.1-channel sound, all the speakers, except for
the subwoofer, should be the same distance from the seating position. If
you have to place the center or surround speakers closer to the seating
position, adjust the delay time to make up for the difference.
If distances d (from the center speaker) and f (from the surround
speakers) are the same as or greater than e (from the front speakers),
leave the delay time as “0”, the factory preset.
If either distance d or f is less than e, find the difference in the relevant
table and change to the recommended setting.
Changing the delay time
1. Press [3, 4, 2, 1] to select the delay time box and press
[ENTER].
2. Press [3, 4] to adjust the delay time and press [ENTER].
1. Press [3, 4, 2, 1] to select “Test” and press [ENTER].
A test signal is output from one speaker at a time, starting with the
front left speaker and proceeding clockwise.
Front (L)_—)Center_—)Front (R)
:;
Surround (LS)(—————=Surround (RS)