Filter
Top Products
20
CATEGORY
CH DATE ON OFF
SP2 ––:–– ––:––SU
CATEGORY
CH DATE ON OFF
SP2 ––:–– ––:––SU-SA
CATEGORY
CH DATE ON OFF
SPA2 ––:–– ––:––––––
CH DATE ON OFF
A2 20:02 21:3027SA
CATEGORY
On Screen Display
To Suspend the Timer Recording Standby
Mode
When you want to use the VCR for playback, normal
recording or some other operation before the programmed
timer recording will be performed, you can temporarily
suspend the timer recording standby mode by pressing the
TIMER (REC) button A so that the [Á] indication on the VCR
display disappears.
However, after you have finished using the VCR, be sure to
reactivate the timer recording standby mode by pressing the
TIMER (REC) button A again otherwise the programmed
timer recording will not be performed.
Weekly Timer Recording
In step 3 of 4-Key Programming,
select the desired day by pressing
the DATE button :.
For example, SU (Sunday)
(SU=Sunday, MO=Monday, TU=Tuesday, WE=Wednesday,
TH=Thursday, FR=Friday, SA=Saturday)
Daily Timer Recording
In step 3 of 4-Key Programming,
select the desired days by pressing
the DATE button :.
For example, C
A Daily recording from Monday to Friday (MO–FR)
B Daily recording from Monday to Saturday (MO–SA)
C Daily recording from Sunday to Saturday (SU–SA)
Timer Recording from an External Signal
Source
If timer recording is performed by a unit connected to the
Audio/Video input sockets, select the A1 or A2 indicator in
step 2 of 4-Key Programming for the programme position.
– If the [DIRECT REC] is set to [ON], A1 is skipped.
Setting other Programmes in Succession
Repeat steps 1–9 of 4-Key Programming.
Programming a Timer Recording of a TV
Programme Until its End
(Tape Speed Auto Change Function )
If the VCR determines that the remaining tape time is
insufficient to record the programme to its end during a timer
recording performed in the SP mode, this function
automatically changes the tape speed to ensure that the
whole programme will be recorded.
The tape speed will change as follows.
PAL system: SP ) LP
NTSC system: SP ) EP
– This function cannot change the recording speed to the
EP mode for PAL system.
Depending on the remaining tape length, recording may be
performed in the LP (EP) mode from the start. However, if the
remaining tape time is still not sufficient in this case, the
programme cannot be recorded to the end.
– The tape length must be set correctly. (See page 13.)
– Some tapes may not work correctly.
– If the recording speed changes from SP to LP during a
timer recording, some brief picture distortion occurs at that
point.
To Activate the Tape Speed Auto Change Function:
Press the SPEED button B to select [A].
– Every time you press the SPEED button B, the indication
changes in the following order:
PAL system:
NTSC system:
SP
A
LP EP
SP
A
EP