Filter
Top Products
61
Operating peripheral equipment using the remote control
Programming The Illuminated Remote Control Using Access Codes
The remote control can be preset for other manufacturers, by utilizing the REMOTE MODE SELECTION BUTTONS for
CABLE, DTV, VCR, RCVR (a Receiver or Amplifier), DVD (DVD, CD, LD) ,DBS and AUX (for Cassette Player or a
VCR2.)
(Details on remote control buttons to operate peripheral equipment See page 63 to 65 and 66 to 68)
1
2
3
Device
TV
VCR
CBL
DBS
RCVR
AUX
DVD
DTV
Operate
TV ( Only Panasonic )
VCR ( Preset )
Cable Boxes ( Preset )
DBS Boxes ( Preset )
RCVR ( Preset )
Cassette Players, VCR2 ( Preset )
DVD & LD & CD Player ( Preset )
STB ( Only Panasonic )
Default
Panasonic Code
Panasonic Code
Panasonic Code
Panasonic Code
Technics Code
Technics Cassette Players Code
Panasonic DVD Code
Panasonic Code
1. Setting up the remote using the numerical keys. (When the code is known):
POWER
CH
VOL VOL
CH
ACTION
Press and hold the POWER and ACTION keys simultaneously for three full
seconds.
After 3 seconds, all the illuminated mode keys will begin to flash.
Release the POWER and ACTION keys.
VCR
DVD
AUX
RCVR
TV
DTV
CBL
DBS
Press the desired mode key.
The mode key will illuminate steadily, all others will go out.
123
456
789
0
Enter the three digit set up code, by using the Remote Control Keyboard.
If the correct code is entered, the mode key will blink twice and then go out.
Now your remote is set for this code.
Note:
If an incorrect number is entered (or there is an incomplete entry after 30 seconds), the key illumination goes out
(no blink) and the settings are unchanged.
+