Filter
Top Products
1 Unwind speaker wire,
then fit the wire back
into the groove of the
speaker base.
2 Twist and pull off the vinyl tip.
3 Connect the speakers.
12
RQT6912
Getting Started
Preparing the multi cradle and power supply
Household AC outlet
(AC 120 V, 60 Hz)
Fit so unit
clicks firmly
into place.
The unit is in the standby condition (the [Í]
indicator lights) when the AC power supply
cord is connected. The primary circuit is
always “live” as long as the AC adaptor is
connected to an electrical outlet.
BEFORE USE
Make sure the built-in battery is attached
whenever you use the unit.
DC IN 9V
PU
LL
Ë
Remove the
insulation sheet
When using only the player
Connect the AC adaptor directly to the player’s
DC IN terminal.
SPEAKER
HAUT
PARLEUR
COMPONENT VIDEO OUT
S VIDEO
OUT
(480P/480I)
YP
B
P
R
SUB
WOOFER
CENTER SORROUND
AUDIO OUT
VIDEO
OUT
5.1ch
2ch (MIX)
FRONT
RLRL
R
4≠
L
+
-
+
-
SPEAKER
HAUT
PARLEUR
4≠
Push the levers and insert the wires.
Light gray
No line
Black line
Dark gray
DC IN 9V
Ë
DC IN 9V
1
2
DC IN
DC IN
4 Attach to cradle.
(When the unit is off)
Make sure built-in battery
is attached.
≥To conserve power
When the unit is not going to be used for a long
time, disconnect the AC power supply cord from
the AC outlet.
The unit consumes a small amount of power
(approx. 0.9 W, when in the multi cradle) when
in standby mode.
∫ To detach
(When the unit is off)
Pull the lever so the unit lifts off the cradle.
Multi cradle (AC adaptor)
Caution
Use the speakers only with
the recommended system.
Failure to do so may lead to
damage to the connected
equipment and/or the
speakers, and may result in
the risk of fire. Consult a
qualified service person if
damage has occurred or if
you experience a sudden
change in performance.
RELEASE
VIDEO
AUDIO
OPT OUT
SD CARD : PUSH RELEASE