Filter
Top Products
8
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com
8
2
/
6
/
2003
THU
12
:
00
P
M
DST
:
O
N
A
UTO
C
L
OCK SET
CO
M
P
L
ETED
SETT
I
N
G
:
CH
1
0
If AUTO CLOCK SET IS INCOMPLETE screen
appears, set the clock using MANUAL CLOCK
SET procedure on next page.
A
UTO
C
L
OCK SET
IS INCO
M
P
L
ETE
PLEASE SET CLOCK BY
PRESSING ACTION KEY
Initial Setup (Ready to Play)
1
Plug the unit power cord into AC wall
outlet.
• If you use a cable box, turn
it on and set it to the Public
Broadcasting Service (PBS)
channel in your time zone.
If you use a DSS receiver, it
must be turned off.
Settings are made automatically. When
setup is done, this screen appears.
For ANT./Cable
Connect the cable from Antenna/Cable
to the VHF/UHF terminal on the unit.
VHF/UHF
VHF/UHF
IN from
ANT./CABLE
VHF/UHF
WARNING:
Overtightening “Nut type” RF coaxial cables
may damage jacks. Finger tighten only.
Please make all cable or antenna connections before power on.
VHF/UHF
VHF/UHF
Cable TV
Converter Box
CH AUTO SET PROCEEDING
PROCEEDING
AUTO CLOCK SET
CANCEL : STOP
3
Connecting
IN from
ANT./CABLE
Press COMBO on the remote for Combo mode.
Press POWER* on the remote or unit.
The unit comes on and auto channel and
clock set starts.
2
UNIT (rear view)
UNIT (rear view)
For DSS/Cable Box
Connect the OUT jack on your cable
box to the VHF/UHF terminal on the unit
with a RF cable.
Connections/Initial Setup (Ready to Play)
• Function buttons are inoperative during Initial
Setup.
• To remove a cassette during Auto Set, press
EJECT twice on the remote or STOP twice on
the unit. In this case, settings must be made
manually. (See page 10.)
• Depending on conditions, Auto Clock Set may
take longer than 30 minutes. If so, press STOP
to stop setup and perform settings manually.
(See page 10.)
Notes