Filter
Top Products
9
Lens iris selector switch [IRIS MANU/AUTO]
The lens is set to automatic iris (ALC) if this switch is set
to [AUTO] when the iris selector switch on the lens is at
[AUTO]. The lens iris can now be finely adjusted using
the lens iris control
by setting the scene file switch
to [USER] and setting [Auto iris adjust] to [ON] using the
camera’s menu in this status.
(For details of the camera menus, refer to the camera’s
operating instructions.)
When the switch is set to [MANU], the lens iris can be
adjusted manually from closed to wide open using the
lens iris control
.
Lens iris control [IRIS LEVEL]
ALC (AGC and ELC) can be finely adjusted by setting
the lens iris selector switch
to [AUTO], the scene file
switch
to [USER], and [Auto iris adjust] to [ON] using
the camera’s menu.
When the lens iris selector switch
is set to [MANU], the
lens iris can be adjusted manually from closed to wide
open.
Note:
The ALC cannot be finely adjusted and the lens iris
cannot be adjusted when the iris selector switch on
the lens is set to a position other than [AUTO] (such as
[MANU]).
With some lenses, the open and close directions with
respect to the control directions may be reversed. If this is
the case, contact the lens manufacturer or your dealer.
Intercom connector [INCOM]
(XLR 4-pin connector)
A headset is connected here. Intercommunication is then
possible between the camera, RCU and live switcher.
Set the INCOM selector switch on the live switcher
(AW-SW350) to the [3-wire type].
1: GND
2: MIC (this is where the headset
microphone is connected)
3: GND
4: SPEAKER (this is where the headset
speaker is connected)
Use a dynamic type of microphone with an impedance
of approximately 200 ohms for the headset to be
connected.
Recommended headset:
HRM-201D (Ashida Sound Co., Ltd)
CC-26K (CLEAR-COM)
Intercom volume adjustment control
[INCOM LEVEL]
This is used to adjust the volume of the sound heard
through the speaker of the headset connected to the
INCOM connector.
Parts and their functions