Filter
Top Products
7
SERIALPC IN
AUDIO
1
2
1
2
1
2
Connections
SPEAKERS
Terminals (R)
SPEAKERS
Terminals (L)
– Cable fixing bands Secure any excess cables with bands as required.
When connecting the speakers, be sure to use only the optional accessory speakers.
Refer to the speaker’s Installation Manual for details on speaker installation.
(Example: TH-42PWD6)
Speakers (Optional accessories)
Pass the attached cable
fixing band through the
clip as shown in the
figure.
To secure cables connected to Terminals, wrap the cable fixing band around
them then pass the pointed end through the locking block, as shown in the
figure.
While ensuring there is sufficient slack in cables to minimize stress
(especially in the power cord), firmly bind all cables with the supplied
fixing band.
From EXTERNAL monitor terminal
on Computer (see page 8)
AC cord connection
(see page 12)
Optional Terminal Board insert Slots (covered)
From SERIAL terminal
on Computer
To tighten: To loosen:
Pull
Pull
Push the catch
3. Slide up the clamper and fix
the AC cord plug securely.
2. Insert the AC cord and
close the clamper
securely.
1. Open the clamper.
Clamper
AC cord
Note: The power plug in the illustration may not be the type fitted to your set.
SLOT1 SLOT2
SLOT3
When loosen
the clamper:
– AC cord fixing