Filter
Top Products
13
Select the input signal
Press the INPUT button to select the input signal to be
played back from the equipment which has been
connected to the Plasma Display.
Power On/Off and input signal selection
Selecting the On-Screen Menu Language
Press to display the Set Up menu.
Press to select your
preferred language.
Selectable languages
English(UK)
Deutsch
Français
Italiano
Español
ENGLISH(US)
.......
(Chinese)
Press to select the OSD Language.
Select the input signals to be connected by installing the optional
Terminal Boards.
Notes:
(1) Input terminal will not be selected if the terminal board is not
installed into the SLOT.
(2) Select to match the signals from the source connected to the
component/RGB input terminals. (see page 30)
(3) In 2 screen display, the same input mode cannot be selected for
the main picture and sub picture.
Input signals will change as follows:
R - STANDBY
G POWER ON
INPUTMENU ENTER
+
-
VOL
MENU ENTERINPUT
+
-
VOL
SURROUND
VOL
NR
INPUT
INPUT
INPUT
SURROUND
VOL
N
PICTURE
SOUND
R
MULTI
SET UP
ZOOM
Setup 1/2
Signal
Screensaver
Input label
Component/RGB-in select
RGB
RGB1
OSD Language
English
(
UK
)
Power save
Off
Standby save
On
Power management
Off
PC ININPUT1 INPUT2 INPUT3
SET UP