Filter
Top Products
11
Connections
How to connect the PC Input terminals
S VIDEO
AV3
VIDEO
LR PC
STRF TV/AV
//
S VIDEO
AV3
VIDEO
LR PC
SD CARD
PUSH-EJECT
PC CARD EJECT
COMPUTER
Ferrite core (Small size)
(supplied)
Less than
10 cm
Stereo plug
Connect a cable which matches the
audio output terminal on the computer.
Less than
10 cm
Less than
10 cm
Conversion adapter
(if necessary)
RGB
PC cable
Ferrite core (Large size)
(supplied)
D-sub 15p
AUDIO
Notes:
• Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and vertical
scanning frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200
lines.)
• The display resolution is a maximum of 640 × 480 dots (TH-37PA30), 768 × 768 dots (TH-42PV30), 1,024 × 768 dots
(TH-50PV30) when the aspect mode is set to “4:3”, and 852 × 480 dots (TH-37PA30), 1,024 × 768 dots (TH-
42PV30), 1,366 × 768 dots (TH-50PV30) when the aspect mode is set to “16:9”. If the display resolution exceeds
these maximums, it may not be possible to show fine detail with sufficient clarity.
• Some PC models cannot be connected to the set.
• There is no need to use an adapter for computers with DOS/V compatible D-sub 15P terminal.
• The computer shown in the illustration is for example purposes only.
• Additional equipment and cables shown are not supplied with this set.
• Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specified
frequency range.
1
678
3
9
45
10
15 14 13 12 11
2
Signal Names for D-sub 15P Connector
Pin Layout for PC Input
Terminal
Pin No.
1
2
3
4
5
Pin No.
6
7
8
9
10
Pin No.
11
12
13
14
15
Signal Name
R
G
B
NC
GND (Ground)
Signal Name
GND (Ground)
GND (Ground)
GND (Ground)
NC (not connected)
GND (Ground)
Signal Name
NC (not connected)
NC
HD/SYNC
VD
NC