Filter
Top Products
10
Audio / Video connections
How to connect the PC Input terminals
Notes:
• Connect a cable which matches the audio output terminal on the computer.
•
Computer signals which can be input are those with a horizontal scanning frequency of 31 to 69 kHz and vertical
scanning frequency of 59 to 86 Hz. (However, the image will not be displayed properly if the signals exceed 1,024 lines.)
• When the aspect mode is set to “4:3”, maximum of 1,024 × 768 dots area of LCD panel is used for display, and
when the aspect mode is set to “16:9”, full area (1,366 × 768 dots) of LCD panel is used for display.
• Some PC models cannot be connected to the set.
• There is no need to use an adapter for computers with DOS/V compatible D-sub 15P terminal.
• The computer shown in the illustration is for example purposes only.
• Additional equipment and cables shown are not supplied with this set.
• Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specified
frequency range.
• For applicable PC signals information see page 37.
Signal Names for D-sub 15P Connector
AV IN
L
R
AUDIO
IN
PC
S VIDEO
COMPONENT
MONITOR
OUT
AV1
IN
AV2
IN
AV4
IN
VIDEO
L
AUDI O
R
P
B
/C
B
Y
P
R
/C
R
MONO MONO MONO
U. S. patent No.4, 907, 093.
L
R
PC IN
AUDIO IN
COMPUTER
RGB
AUDIO
(D-sub 15p)
(Stereo plug)
Conversion adapter (if necessary)
1
678
3
9
45
10
15 14 13 12 11
2
Pin No. Signal Name Pin No. Signal Name Pin No. Signal Name
1
R
6
GND (Ground)
11
NC (not connected)
2
G
7
GND (Ground)
12
NC (not connected)
3
B
8
GND (Ground)
13
HD/SYNC
4
NC (not connected)
9
NC (not connected)
14
VD
5
GND (Ground)
10
GND (Ground)
15
NC (not connected)
Pin Layout for PC Input
Terminal
Power On / Off
Connect the mains plug to the wall socket.
Press the [
] switch on the TV set to turn the
set on.
To switch the TV set to Standby mode, press the
button on the remote control.
The TV set can be switched on by pressing the
button again if it was in Standby mode.
Note:
This TV will still consume some power
as long as the mains plug is still inserted
into the wall socket.
TV
123
456
7
89
0
OK
Power Indicator
Remote control signal sensor
Within about 23 feet (7 meters) in
front of the TV set.
Standby : Red
On : No Light
C.A.T.S. sensor
LCD C.A.T.S. (Contrast Automatic Tracking System) automatically
senses the ambient light conditions and adjusts the brightness
and gradation accordingly, to optimize contrast.
C.A.T.S. is in effect when Menu mode (page 17) is set to Auto.
Main POWER switch