Filter
Top Products
Tuning and Editing Channels (DVB)
38
Set DVB channel manually [Manual Tuning]
Normally use [Auto Setup] or [Update Channel List] to retune DVB channels.
If tuning has not been done completely or for adjusting the direction of the aerial, use this function.
t
All channels found will be added to the Channel List.
DVB-C :
1 Enter the frequency 2 Search
Auto
Auto
474,00 MHz
100%
100%
Stopped
No. Channel Name Type New
Free TV: 0 Pay TV: 0 Radio: 0
DVB-C Manual Tuning
Frequency
Symbol Rate
Service ID
Signal Quality
Signal Strength
jkl
ghi
mno
tuvpqrs
wxyz
abc def
t
Normally set [Symbol Rate] and [Service
ID] to [Auto].
DVB-T :
1 Adjust frequency for each channel 2 Search
[CH21]
100%
100%
Stopped
No. Channel Name Type New
Free TV: 0 Pay TV: 0 Radio: 0
DVB-T Manual Tuning
Frequency
Signal Quality
Signal Strength
474,00 MHz
Data: 0
adjust frequency
select channel
t
Set where the level of [Signal Quality]
becomes the maximum.
Update DVB channel automatically [Update Channel List]
You can add new channels, delete removed channels, update channel name and position automatically to Channel List.
69CH 5
Searching
CH Channel Name Type Quality
DVB-T Update Channel List
Progress
Free TV: 0 Pay TV: 0 Radio: 0
This will take about 3 minutes.
t
Channel List is updated while keeping your settings in [Favourites Edit],
[Channel List], [Child Lock], etc.
t
Depending on the signal condition, the update may not work properly.
Display a notification message [New Channel Message]
Selects whether to give a notification message when a new DVB channel is found. [Off] / [On]
New channels found!
Press OK to update channel list.
Press EXIT to ignore.
t
Selecting OK will perform [Update Channel List].
Check DVB signal [Signal Condition]
Selects a channel and checks the DVB signal condition.
A good Signal Strength is not an indication of suitable signal for DVB reception.
Please use the Signal Quality indicator as follows :
[Signal Quality] :
t
Green bar Good
t
Yellow bar Poor
t
Red bar Bad (Check the Terrestrial aerial or cable)
t
To change the channel
Channel Name
Signal Quality
Signal Strength
Bit Error Rate
Network Name
Parameter
70 CBBC Channel
Wenvoe
0.00E+00
802,00 MHz, 64 QAM, 6940 kS/s
DVB-C Signal Condition
90%
80%
These bars show the maximum signal value of the selected channel.
Reduce the DVB-C signal [Attenuator]
If the DVB-C signal is too strong, the interference may occur. In this case set to [On] to reduce the signal automatically.
t
This function is available only for DVB-C signal.