Filter
Top Products
Troubleshooting
Others
103
LSQT1184
Problem Check points
The DISC EJECT lever
does not work.
≥ The disc cover will not open unless the unit is powered.
# Connect a charged battery or AC adaptor.
The disc cannot be read.
≥ Are there fingerprints or dirt on the surface of the disc?
# If there are fingerprints or dirt on the disc, wipe them off.
(l 17)
A function indication
such as mode indication,
remaining time
indication, or elapsed
time indication is not
shown.
≥ If you set [SETUP]>[DISPLAY]>[OFF], indications other
than warnings and date indications disappear.
Recording does not start
although power is
supplied to this unit and
the disc or card is
correctly inserted.
≥ Is the DVD-RAM or the DVD-RW (VR format) write-
protected?
# Release the protection. (l 84) If the DVD-RAM or DVD-RW
(VR format) was protected on another device, release the
protection on the same device.
≥ Has the DVD-RW (Video format) or DVD-R been finalized?
# After finalizing, the discs become play-only and cannot
record. If you un-finalize a DVD-RW (Video format), it can be
used for recording. (l 83)
≥ Has the SD card’s write protect switch been set to LOCK?
# No recording is possible while the write protect switch is set
to LOCK. (l 16)
≥ Is the memory of the disc or card full?
# If the disc or card has no more available memory, free up
some memory by deleting unnecessary scenes (l 63, 76) or
use a new disc or card.
≥ Is the unit set to the disc recording mode or card recording
mode?
# No recording is possible unless the mode dial is at or
.
≥ Is the disc cover open?
# If the cover is open, this unit may not operate normally. Close
the disc cover.
Recording starts but
stops immediately.
The playback picture
breaks up for a moment.
≥ Is the disc scratched or dirty?
# Clean the disc. (l 17)
≥ The unit is hot. Follow the messages on the display.
To use the unit again, turn the unit off and leave it for a
while.
LSQT1184(ENG).book 103 ページ ２００７年２月５日 月曜日 午後１時２９分