Filter
Top Products
-11-
■ Troubleshooting
-
7, 9
Use the supplied cable and connect it
securely.
Hard Disk Detection switch
SCSI ID setting
SCSI cable
SCSI connection
Power switch
Set to the INSTALLED position.
Set ID number properly
Use the supplied cable and connect it
securely.
Install extension units in the specified order.
Turn on the power switch (peripherals) first,
then the power of the WJ-HD500.
In case of turning On or Off the power, plug
the power cord to an AC outlet connected
to the WJ-HD500.
Dirt or dust on the optical lens or
DVD-RAM disc
Write disabled.
DVD-RAM disk cannot be format-
ted.
Cannot copy to DVD-RAM disk.
Extension HDDs are not recog-
nized.
Remove disk after copying or playback is
completed.
6, 7
12
Confirm the type of DVD-RAM disk.
Phenomenon Cause What to do
No power is supplied.
Power cord is not firmly connect-
ed.
Securely plug the cord into AC outlet and
AC inlet.
Thermal error.
OPERATE indicator lights in
orange.
DVD-RAM drive is not recog-
nized.
Ambient temperature is too low.
Ventilation openings or fan is
blocked.
Use the unit within +5˚C to +45˚C.
Remove obstacles.
Cooling fan failed. Consult your dealer for replacement.
SCSI cable
Use the supplied cable and connect it
securely.
Page
–
–
2
5
7, 9
DVD-RAM disk type 2
Use the optional cleaning disc.
Dirt or dust of the optical lens or
DVD-RAM disc
3
Set it to ”Write enable”.
Cannot remove the DVD-RAM
disk.
2
Use the optional cleaning disc.
3
See page 12.
Operate indicator is blinking in
green.
Recorded data is being copied or
played back.
HDD indicator blinks. SCSI cable
AC outlet