Filter
Top Products
Torque: 0.49 N•m (5 kgf•cm)
7. Set the unit address with the jumper connector on
the HDD.
Note: For further information, refer to the instructions
supplied with the HDD unit.
8. Hold the HDD on both sides and place it into the
specified bay. Then fix it with two of the fixing
screws in step 3.
Torque: 0.49 N•m (5 kgf•cm)
Note: To install one HDD, place it into bay #1.
-7-
Fixing Screw x 4
(supplied)
Sleeves (supplied)
Earth Lug
(supplied)
HDD
Jumper Connector
9. Plug the two harness connectors into the installed
HDD, and replace the HDD lid.
10. Repeat the above steps for HDD #2.
11. Set the Hard Disk Detection switch to INSTALLED.
R
A
M
H
D
D
H
D
D
H
D
D
H
D
D
RA
M
Jumper connector
HDD #2 (SLAVE)
HDD #1 (MASTER)
Jumper Position
Jumper Position
■ Connection and Switch Setting
The figures show examples of SCSI connections.
The WJ-HD500 Digital Disk Recorder controls the
DVD Extension Unit through the SCSI chain.
<Connection between the WJ-HD500 and a
WJ-HDE510 without HDD>
The figure shows a WJ-HDE510 without an HDD. The
DVD-RAM is used for backup of the data recorded on
the WJ-HD500 Digital Disk Recorder.
1. Connect between the COPY port on the WJ-
HD500 and the COPY IN port on the 1st DVD
Extension Unit with the supplied (WJ-HDE510)
SCSI cable.
Plug the cable end with magnetic core into the
COPY port, and the other ends into the COPY IN
port.
2. Connect between the EXT STORAGE port on the
WJ-HD500 and the EXT IN port on the 2nd
Extension Unit with the supplied (WJ-HDE510)
SCSI cable.
Plug the cable end with magnetic core into the
EXT STRAGE port, and the other ends into the
EXT IN port.
The system can be expanded by up to 6
Extension Units. To connect the other Extension
Units, refer to the operating instructions of each
unit for further information.
16
16
15
15
14
14
13
13
12
12
11
11
10
10
9
9
8
8
7
7
6
6
5
5
4
4
3 2
23
1
1
SIGNAL GND
SPOT
OUT
IN EXT STORAGE COPY
CONTROL ALARM
VIDEO
MODE
DATA
REMOTE
(WV-CU50)
SERIAL
POWER
ON
AC
IN
OFF
IN
OUT
OUT
MULTI SCREEN OUT
AUDIO
SCSI ID
TERMINATOR
-
+
1
GND
ON
OFF
SIGNAL
AC IN
POWER
EXT IN
COPY IN
EXT OUT
G
NC
THERMAL ERROR OUT
ON
OFF
HDD
INSTALLED
NOT INSTALLED
COPY port
CONTROL port
EXT IN
SIGNAL GND
POWER
AC IN
SCSI ID
EXT OUT
EXT IN
TERMINATOR
GND
THERMAL ERROR OUT
NC
+
–
OFF
ON
ON
OFF
Terminal board
DVD Extension Unit #1
WJ-HDE510
SCSI ID= not set
SCSI cable
(supplied with
Extension Unit)
SCSI cable (supplied)
Extension Unit #2
WJ-HDE500/HDE505
SCSI ID=0 to 5
Digital Disk Recorder
WJ-HD500
SCSI ID=6 and 7
COPY IN
EXT
STORAGE