Filter
Top Products
2. Remove the HDD lid.
2-1 Loosen the HDD lid fixing screw.
2-2 Slide the HDD lid to the right and remove the
screw.
3. Remove the HDD brackets #1 and #2.
3-1 Loosen two screws.
3-2 Pull bracket #1 out of the bay.
Note: Keep the four removed fixing screws for
use in step 8.
4. Insert the four HDD absorbers (supplied) so that the
grooves are caught in the fixing bracket.
5. Prepare an HDD unit.
Notes:
• Put your hand on a metallic surface to discharge
static electricity before taking out the dampers
from the case.
• Place the case with the HDD on a soft surface
such as a cushion mat with the circuit board
side up to discharge static electricity.
6. Hold the HDD on both sides and place it on the fix-
ing bracket. Then fasten it with the four screws,
sleeves and earth lugs.
Note: Never use an electric screwdriver to prevent
shock.
-6-
■ Installing the Optional Hard
Disk
A maximum of two HDD units (procured locally) can be
installed in the DVD Extension Unit. The following
describes how to install HDD #1 (MASTER). To install #2
HDD, repeat the steps described for #1 HDD.
Install the HDD units in the bays in the following order.
Neveer skip or reverse the order of the HDD units.
1. Turn on the power switch located on the rear panel
of the DVD Extension Unit and disconnect the power
cord from an AC outlet.
HDD #1
HDD #2
WJ-HDE
Unit
Extension
HDD
HDD
2
1
OPERATE LED WILL CHANGE TO ORANGE
IF THE INSIDE TEMPERATURE EXCEEDS OR FALLS BELOW THE LIMIT.
OPERATE
HDD Positions Inside the Lid
H
D
D
H
D
D
R
A
M
R
A
M
H
D
D
H
D
D
■ Removal of the DVD-RAM
disk from the DVD
Extension Unit
Before removing the DVD-RAM disk from the DVD
Extension Unit, carry out the following two steps with the
DVD recorder.
1. Delete the menu and list display screens.
2. Press the COPY button for 2 seconds or more
and confirm that ”DVD UNLOCKED” is dis-
played in the center of the monitor screen.
1. Press the DVD-RAM lid to open on the front of the
DVD Extension Unit and press the OPEN/CLOSE
button.
2. The DVD-RAM tray slides out. Remove the disk.
Note: Emergency eject
If you are unable for some reason to open the
drive with the OPEN/CLOSE button, first make
sure that the power of the DVD Extension Unit is
turned off, and then open the drive by inserting
the supplied eject pin into the eject hole on the
front of the drive.
R
O
M
Eject Pin (supplied)
Eject Hole
Absorber x 4
(supplied)
Fixing Bracket