Filter
Top Products
10 SmartNode 10200 Series Quick Start Guide
A.0 Compliance Information
A.1 Compliance
EMC:
•
FCC Part 15, Class A
•
EN55022, Class A
•
EN ETSI 300 386 V1.3.3
Low-Voltage Directive (Safety):
•
UL 60950-1/CSA C22.2 No. 60950-1
•
IEC/EN60950-1
A.2 Radio and TV Interference (FCC Part 15)
This device generates and uses radio frequency energy, and if not installed and used properly—that is, in strict
accordance with the manufacturer's instructions—may cause interference to radio and television reception. This
equipment has been tested and found to comply with the limits for a Class A computing device in accordance with
the specifications in Subpart B of Part 15 of FCC rules, which are designed to provide reasonable protection from
such interference in a commercial installation. However, there is no guarantee that interference will not occur in
a particular installation. If the equipment causes interference to radio or television reception, which can be
determined by disconnecting the cables, try to correct the interference by one or more of the following mea-
sures: moving the computing equipment away from the receiver, re-orienting the receiving antenna, and/or
plugging the receiving equipment into a different AC outlet (such that the computing equipment and receiver are
on different branches).
A.3 CE Declaration of Conformity
Patton Electronics, Inc declares that this device is in compliance with the essential requirements and other rele-
vant provisions of Directive 1999/5/EC. The Declaration of Conformity may be obtained from Patton Electron-
ics, Inc at www.patton.com/certifications.
The safety advice in the documentation accompanying this device shall be obeyed. The conformity to the above
directive is indicated by CE mark on the device.
A.4 Authorized European Representative
D R M Green
European Compliance Services Limited.
Avalon House, Marcham Road
Abingdon,
Oxon OX14 1UD, UK