Filter
Top Products
Configuring HyperTerminal 33
Model 1195 Getting Started Guide 4 • Connecting the RS-232 port
5. Change the Bits per second option to 19200 and change the flow control option to None.
The COM Properties settings should be:
6. Click Apply, then click OK.
7. A new HyperTerminal session screen will display. Press Enter. The system prompt will appear on the
screen. This prompt is generated by the system. Now, you may access/configure the system with the CLI
commands.
Note Remember to save the settings for future use before you exit the HyperTer-
minal window.
Bits per second 19200
Data bits 8
Parity None
Stop bits 1
Flow control None