Filter
Top Products
Specific Commands 43
Model 1195 Getting Started Guide 5 • CLI configuration
Set / configure the Ethernet Port performance parameters
Check the Ethernet Port configuration
Command Response Notes
1195#setport [port] [AN] [rate]
[duplex] [flow]
{enter}
Port=A, AN=B, Rate=C, Duplex=D,
Flow=E
Configure the Ethernet port perfor-
mance parameters, where:
A=1 (Ethernet Port No.)
B=0:AN not done, 1:AN done
C=0:10Mbit/s; 1:100Mbit/s
D=0:half-duplex; 1:full-duplex
E=flow-control capability; 0:disable;
1:enable
Command Response Notes
1195#showport
{enter}
Shows the Ethernet port configura-
tion. See example below.
Shows the Ethernet port configura-
tion.