Filter
Top Products
Connecting the optical interface 26
Model 1195 Getting Started Guide 3 • Model 1195 installation
Connecting the optical interface
For Testing: Always Install Optical Attenuators. For distances of less than 10
km, optical attentuators must be intalled on the Optical Links. Otherwise, the
optics will be permanently damaged.
WARNING
DC 48 V
E1 4-1
II
~ 220 V
PGND
GND
-48V
OPTICAL B
TX RX
OPTICAL A
TX RX
RS232
CONSOLE
Transmit
Optical Signal
through Optical
Fiber Cable
Receive
Optical Signal
through Optical
Fiber Cable
Note: Do not expose to the naked eye.
Connect fiber cable to system
when power is OFF.