Filter
Top Products
Specific Commands 42
Model 1195 Getting Started Guide 5 • CLI configuration
View the current status of laser port
Reset the system
Set / configure the default settings in the device
Enable / Disable the Ethernet Port
Command Response Notes
1195#showlaser
{enter}
View the status of laser interface.
Include alarm status, the config of
receive mode, the current work inter-
face.
View the status of laser interface.
Include alarm status, the config of
receive mode, the current work inter-
face.
Command Response Notes
1195#reset
{enter}
Performs a hot restart. Performs a hot restart.
Command Response Notes
1195#setdefault
{enter}
The default settings have been suc-
cessfully loaded in the system. Reset
the system.
Configures the default setting in the
system.
Note: You must restart the system
after executing this command.
Command Response Notes
1195#enableport [port]
[Enable/Disable]
{enter}
Port = A
Enable/Disable = B
Enable/Disable the Ethernet port,
where:
A=1 (Ethernet Port No.)
B=0:Disable, 1:Enable